BB-IDE-SATA04 Parallel ATA to Serial ATA Host Bridge Board

IDE-SATA04 is ideally suited for tailgate interface applications for Serial ATA HDD. It allows Serial ATA drive to be connected to IDE (Parallel ATA) bus in a bridging fashion. IDE-SATA01 provides the perfect solution for legacy IDE (Parallel ATA) controller to adopt Serial ATA hard disk drive.

BB-IDE-SATA04 Parallel ATA to Serial ATA Host Bridge Board Feature:

•  Parallel ATA to Serial ATA Bridge Board:
   
  • Serial ATA:
    - Compliant with Serial ATA 1.0
    - 48-bit sector addressing
  • Serial ATA Connector:
    - Signal + Power Type
  • Parallel ATA:
    - Ultra ATA Parallel Interface
    - 48-bit sector addressing
          - Jumper for selecting Master and Slave
          - Jumper for setting Auto, ATA100/133/150 Transfers Interface
  • Parallel ATA Connector:
    - Female IDC 2X20 pin Connector
  • Transfer Rate:
    - Supports PIO and DMA modes
    - Supports bus master DMA at 1.5Gbps burst rate
  • DC Power Connector:
    - Mini 4-pin floppy type power connector
  • Physical Dimensions:
    - 4" x 1" (10.15cm x 2.54cm)
    - Direct Connect Vertical type
  • Compatible with Bare-Bone Series Products: IEEE1394a, IEEE1394b or USB2.0 Enclosure

Hardware Requirements

OS Requirements

Additional Links / Notes