BB-IDE-SATA01 Parallel ATA to Serial ATA Host Bridge Board
       
   
   
   

 

 
   
   
       
 

 
IDE-SATA01
Parallel ATA to Serial ATA  Host Bridge Board (1.5Gbps) featuring Marvell 88SA8040 Serial ATA Controller

IDE-SATA01 is ideally suited for tailgate interface applications for Serial ATA HDD. It allows Serial ATA drive to be connected to IDE (Parallel ATA) bus in a bridging fashion. IDE-SATA01 provides the perfect solution for legacy IDE (Parallel ATA) controller to adopt Serial ATA hard disk drive.

 

BB-IDE-SATA01 Parallel ATA to Serial ATA Host Bridge Board Feature:
bluebullet.gif (834 bytes)
  •  Parallel ATA to Serial ATA Bridge Board:
     
    • Serial ATA:
      - Compliant with Serial ATA 1.0
      - 48-bit sector addressing
    • Serial ATA Connector:
      - Signal + Power Type
    • Parallel ATA:
      - Ultra ATA/133 Parallel Interface
      - 48-bit sector addressing
            - Jumper for selecting Master and Slave
    • Parallel ATA Connector:
      - Female IDC 2X20 pin Connector
    • Transfer Rate:
      - Supports PIO and DMA modes
      - Supports bus master DMA at 1.5Gbps burst rate
    • DC Power Connector:
      - Mini 4-pin floppy type power connector
    • Physical Dimensions:
      - 4" x 1" (10.15cm x 2.54cm)
      -       Direct Connect Vertical type
      •

Hardware Requirements
bluebullet.gif (834 bytes) Serial ATA Interface device

OS Requirements
bluebullet.gif (834 bytes) Windows 98, ME, NT4, XP, 2000, 2003, Netware, Linux

Additional Links / Notes
bluebullet.gif (834 bytes) About Serial ATA
 
 

 


    

Specifications are subject to change without notice.
All brands and product names are trademarks of their respective companies
All Products are made in Taiwan